admin管理员组文章数量:1531792
2024年6月11日发(作者:)
MDS9124 LICENSE激活端口操作指南
1.加电启动,进入命令行配置模式
2.查看主机Host-id并记录下来
MDS9214#show license host-id 3、在/go/license/pub
lic 登录,使用Host-id和License Key申请获得许可证文件(一个扩展名为li
c的文件)。
(注意事项:必须使用以FOX开头的host-id,绝对不能使用以JAB开头的设备
SN number进行申请,否则将导致注册失败而且License Key失效!!!!)
4.获得CISCO许可证文件(文件扩展名为lic)后,复制许可证文件到交换机
内的CF卡上:
MDS9214#copy tftp:///
boothflash:
5.安装许可证文件
MDS9124#install license bootflash:/
6.查看许可证使用情况
MDS9124#show license usage
详细设置请登陆CISCO网站查询配置手册:
/en/US/products/ps5989/products_installation_and_conf
iguration_guides_
port-license
To make a port eligible or ineligible to acquire a port activation license on a Cisco MDS 9124 switch,
use the port-license command.
port-license acquire
no port-license acquire
Syntax Description
acquire
Grants a license to a port.
Defaults
None.
Command Modes
Interface configuration submode.
Command History
Release
3.1(1)
Modification
This command was introduced.
Usage Guidelines
If a port already has a license, then no action is taken and the port-license command returns
successfully. If a license is unavailable, then the port will remain unlicensed.
Note This command is supported on the Cisco MDS 9124 switch only.
Examples
The following example shows how to make a port eligible to acquire a license:
switch# config t
switch (config)# interface fc1/1
switch (config-if)# port-license
The following example shows how to acquire a license for a port, and then copies the configuration
to the startup configuration so that the new licensing configuration is maintained:
switch# config t
switch(config)# interface fc1/1
switch(config-if)#
switch(config-if)# port-license acquire
switch(config-if)# end
switch# copy running-config startup-config
Related Commands
Command
show
port-licenses
Description
Displays port licensing information for a Cisco MDS 9124
switch.
版权声明:本文标题:MDS9124 LICENSE激活端口操作指南 内容由热心网友自发贡献,该文观点仅代表作者本人, 转载请联系作者并注明出处:https://m.elefans.com/dianzi/1718040271a637282.html, 本站仅提供信息存储空间服务,不拥有所有权,不承担相关法律责任。如发现本站有涉嫌抄袭侵权/违法违规的内容,一经查实,本站将立刻删除。
发表评论