admin管理员组文章数量:1531793
2024年7月12日发(作者:)
RG-ES106D-P
交换机快速安装指南
Quick Installation Guide
锐捷以太网PoE供电交换机快速安装指南
Quick Installation Guide of Ruijie Ethernet PoE Switches
设备安装 Install the switch
将交换机正面朝上置于足够大且干净平稳的桌面上即可。
Place the switch right-side up on a big enough, clean, stable and flat desktop.
设备连接 Connect the switch
-
-
本交换机支持端口自动翻转(Auto MDI/MDIX),用网线连接交换机与对端以太网设备时,使用直连线
或交叉线均可。
本交换机PoE端口支持优先级机制,当受电设备的总功耗超过交换机整机最大PoE供电功率时,交换
机将按照1>2>3>4的优先级顺序,切断优先级最低的端口的供电,直至受电设备的总功耗恢复到交换
机整机最大PoE供电功率以内。
警 告
此为A级产品,在生活环境中,该产品可能会造成无
线电干扰,在这种情况下,可能需要用户对干扰采
取切实可行的措施。
Tips
−
−
All ports of the switch support the auto MDI/MDIX function, so both a straight cable and a
crossover cable can be used to connect the switch to Ethernet devices.
PoE ports of the switch are assigned with power supply priorities, and the priorities
decrease as the port number increases (1 > 2 > 3 > 4). When the total power consumption of
the PoE-powered devices exceeds the maximum output of the switch, the switch starts
cutting the power supply from the port with the lowest priority until the total consumption
is less than the maximum output.
Warning
This is a Class A product. In a domestic environment,
this product may cause radio interference, in which
case the user may be required to take adequate
measures.
请参考下表检查设备连接是否正确或调节交换机工作模式。
Refer to the following table to check whether the connections of the switch are
proper, or adjust the operating mode of the switch.
指示灯/开关
PWR
*位于后面板
PoE
*位于PoE口右上角
说明
长亮:交换机通电正常。
熄灭:交换机未通电或通电异常。
长亮:端口已连接受电设备,并供电正常。
熄灭:端口未连接受电设备,或没有供电。
长亮:端口已连接。
Link/Act
*位于网口左上角
闪烁:端口正在传输数据。
熄灭:端口未连接,或连接异常。
指示灯/开关 说明
工作模式拨码开关。
标准模式:此模式下,交换机为普通非网管型PoE供电交换机,
所有端口之间可以相互通信。
流控关闭:此模式下,交换机关闭所有端口流控,以满足各种复
杂环境的“网络克隆”需求。
端口隔离:此模式下,1~4号端口不能互相通信,但都能与5和
6号端口通信。可以减少广播风暴,隔离DHCP广播。
*位于后面板
LED indicator/Toggle
PWR
*On the rear panel
Description
Solid on: The switch is connected to a power source properly.
Off: The switch is disconnected from a power source or not properly connected
to a power source.
Solid on: The corresponding port is connected to a powered-device, and supply
PoE
power properly.
*On the upper-right corner of
Blinking: The power consumption of the powered-device connected to the
corresponding port is too large.
each PoE port
Off: The port does not supply power to any powered-device.
Solid on: The corresponding port is connected properly.
Link/Act
Blinking: Data is being transmitted over the corresponding port.
*On the upper-left corner of
Off: The corresponding port is disconnected or not connected properly.
each Ethernet port
Toggle for switching operating modes
− Standard Mode: In this mode, the switch functions as a common
unmanaged PoE switch, and all ports of the switch can communicate with
each other.
− Flow Control-OFF: In this mode, the switch disables the flow control
function for all ports to meet the demand of PC network clone in various
environments.
*On the real panel
− Port Isolation: In this mode, ports 1 to 4 cannot communicate with each
other, but can communicate with ports 5 and 6 respectively, which helps
reduce broadcast storm and isolate DHCP broadcast.
规格参数 Specifications
产品型号
10/100Mbps RJ45端
端口
口
工作模式
交换模式
性能 MAC地址表
MAC地址学习
RG-ES106D-P
6
支持三种模式切换:标准模式、流控关闭、端口隔离
存储转发
1K
自动学习、自动老化
产品型号
背板带宽
PoE供电端口
PoE供电标准
PoE供电 PoE供电电芯
端口最大供电功率
整机最大供电功率
外形尺寸(长×宽×高)
电源适配器
输入
输出
RJ45端口
电源
RG-ES106D-P
1.2Gbps
1~4
IEEE 802.3at、IEEE 802.3af
8芯供电(1 2 4 5为+,3 6 7 8为-)
30W
58W
100mm×100mm×26mm
100~240V AC,50/60Hz,1.5A
51V DC,1.25A
共模:6kV
共模:4kV; 差模:2kV
工作温度:0℃~45℃
工作湿度:(10~90)%RH,无凝结
存储温度:-40℃~70℃
存储湿度:(5~90)%RH,无凝结
以太网:3类或以上UTP/STP
快速以太网:5类或以上UTP/STP
IEEE 802.3、IEEE 802.3u、IEEE 802.3x、IEEE 802.3af、IEEE
802.3at
GB9254-2008
GB4943-2011
防雷
工作环境
存储环境
网络介质
网络标准
EMC
安规
Model
10/100 Mbps RJ45 port
Port
Operating mode
Switching mode
Performance
MAC address table
MAC address learning
Backplane bandwidth
PoE port
PoE Power PoE standard
PoE power cable core
RG-ES106D-P
6
Three operating modes are supported: Standard Mode, Flow
Control-OFF and Port Isolation
Store-and forward
1 K
Auto-learning, auto-aging
1.2 Gbps
1 - 4
IEEE 802.3at, IEEE 802.3af
8 cores: cores 1, 2, 4, 5 are +, and cores 3, 6, 7, 8 are -
Model
Maximum output
power of a single port
Maximum output
power of the switch
Dimensions (L x W x H)
Power
adapter
Lightning
protection
Input
Output
RJ45 port
Power
RG-ES106D-P
30 W
58 W
100 mm x 100 mm x 26 mm
100 - 240V AC, 50/60Hz, 1.5A
51V DC, 1.25A
Common mode: 6 kV
Common mode: 4 kV, Differential mode: 2 kV
Operating temperature: 0°C - 45°C
Operating humidity: (10% - 90%) RH, non-condensing
Storage temperature: -40°C - 70°C
Storage humidity: (5% - 90%) RH, non-condensing
Ethernet: CAT3 UTP/STP cable or better
Fast Ethernet: CAT5 UTP/STP cable or better
IEEE 802.3, IEEE 802.3u, IEEE 802.3x, IEEE 802.3af, IEEE 802.3at
GB9254-2008
GB4943-2011
Operating environment
Storage environment
Network media
Network standard
EMC Standards
Security Standards
如需了解产品及安装方面的更多信息,请登录锐捷网络网站
For more information about the product and installation procedures, log in to
锐捷网络股份有限公司 版权所有,保留一切权利
锐捷网络股份有限公司
福州市金山大道618号橘园洲工业园区星网锐捷科技园
技术支持:
远程技术服务中心:+86-400-100-0078(China)
官网:
Copyright @ ruijie networks Co., Ltd.
RUIJIE NETWORKS CO., LTD.
Ruijie Science and Technology Park, Juyuanzhou, No. 618, Jinshan Road, Fuzhou
Technical Support:
Technical Support Hotline: +86-400-100-0078(China)
Website:
版权声明:本文标题:锐捷RG-ES106D-P PoE供电以太网交换机快速安装指南说明书 内容由热心网友自发贡献,该文观点仅代表作者本人, 转载请联系作者并注明出处:https://m.elefans.com/dianzi/1720790660a843078.html, 本站仅提供信息存储空间服务,不拥有所有权,不承担相关法律责任。如发现本站有涉嫌抄袭侵权/违法违规的内容,一经查实,本站将立刻删除。
发表评论