admin管理员组

文章数量:1596328

If the Breaker block happens to be in series

with an inductive circuit, an open circuit or a current

source, you must use a snubber.

2.Parameters:

Snubber resistance Rs_The snubber resistance, in ohms (). Set the

Snubber resistance Rs parameter to inf to

eliminate the snubber from the model.

Snubber capacitance Cs_The snubber capacitance, in farads (F). Set

the Snubber capacitance Cs parameter to 0

to eliminate the snubber, or to inf to get a resistive

snubber.

3.Limitations

When the block is connected in series with an inductor or another

current source, you must add the snubber

circuit.

In most applications you can use a resistive snubber (Snubber

capacitance parameter set to inf) with a large resistor value (Snubber resistance parameter set to

1e6 or so).

Because of modeling constraints, the internal breaker inductance

Ron cannot be set to 0.

You must use a stiff integration algorithm to simulate circuits

with the Breaker block. ode23tb or ode15s

with default parameters usually gives the best simulation

speed.

本文标签： 器件matlabMATLABBREAKERBreaker

版权声明：本文标题：MATLAB器件Breaker,MATLAB_BREAKER 内容由热心网友自发贡献，该文观点仅代表作者本人， 转载请联系作者并注明出处：https://m.elefans.com/dianzi/1728256401a1151066.html， 本站仅提供信息存储空间服务，不拥有所有权，不承担相关法律责任。如发现本站有涉嫌抄袭侵权/违法违规的内容，一经查实，本站将立刻删除。