admin管理员组文章数量:1576390
切削仿真常见问题及其解决
2014
年
10
月
17
日
14:03
【关于截面定义】
1.
进行二维切削仿真时,定义的截面属性要勾选平面应变应力厚度,而且
一定要将默认值
1
改为实际要仿的切削深度(对于车削,为径向车削深度)
尤其是以米为单位时。
1.
网格过度变形(
mesh
distorted exessively
):可能原因有:切屑分离临界值定义过
高;材料参数数量级错误;如果定义了
ALE
可以减小
remeshing frequency
的值从而提高
网格重划分频率。
ERROR: There are a total of 7 excessively distorted elements
The following checklist may be helpful in diagnosing the error:
1. Check contact definitions for problems such as excessive initial
overclosure or unrealistic tied definition between contact pairs.
A vector plot of velocities or accelerations will usually help to
identify contact problems.
2. Check stiffness (elastic modulus) and mass (density) definitions for
consistent units and verify that the combination is reasonable.
3. Check for poor mesh definition.
4. Check the boundary conditions for an excessive loading rate. The
*DIAGNOSTICS, DEFORMATION SPEED CHECK=DETAIL option may be used to
obtain
detailed diagnostics information.
5. Check the current status of the structure to see if it has
totally failed.
6. A dashpot or a very stiff spring may cause the analysis to go unstable.
The *DYNAMIC, DIRECT option may be used to control the time increment
directly.
2.
发现有网格剧烈变形呈突刺状:碰到过的原因有两种:
1
)
field
output
中没有勾选
state
里面的
STATUS
变量,突刺状网格实际上是已经破坏掉的网格,勾选
status
变量可
以使已破坏的网格不显示。
2
)定义刀具与工件的
face to face contact
时,刀具前后刀
面作为主接触面方向定义反了。
3.
刀具穿透网格:接触定义有问题,刀具与切削区的接触定义不正确或没有定义。一般来
说
,
采用面点接触或面面接触较好
.
4.
切削区变形很大仍然无法分离:切屑分离临界值定义过高,或其它材料参数设置有问
题。
5.
当切削仿真时出现左图无法分域错误
(domain decomposition):
可能是
job
里面定义了多
核并行运算
,
而一些接触对
,adaptive mesh
是不能分域的
,
此时只需按下图取消多核运算即
可。
版权声明:本文标题:abaqus切削为什么没有切屑_Abaqus切削仿真常见问题及其解决个人总结 内容由热心网友自发贡献,该文观点仅代表作者本人, 转载请联系作者并注明出处:https://m.elefans.com/dongtai/1727798202a1130511.html, 本站仅提供信息存储空间服务,不拥有所有权,不承担相关法律责任。如发现本站有涉嫌抄袭侵权/违法违规的内容,一经查实,本站将立刻删除。
发表评论