admin管理员组文章数量:1576894
cisco packet tracer实验案例-重置路由器ENABLE特权密码
0 文章标签: cisco, 路由器cisco路由器ENABLE密码忘记了怎么办?通过本实验你将熟悉当cisco路由器ENABLE密码忘记了改如何重置ENABLE特权密码的过程
实验目的及要求:
实验目的:恢复路由器的密码
实验要求:重设路由器的ENABLE密码不允许丢失路由器已有的配置
实验拓扑:1台cisco 2621路由器。
实验步骤
1、启动2621路由器,进入ENABLE模式,配置ENABLE密码。命令如下:
Router>en Router#conf t Enter configuration commands, one per line. End with CNTL/Z. Router(config)#enable password www.wusoft //设置特权密码 Router#wr //保存配置 Building configuration...
2、重置路由器特权密码
正常情况应是忘记路由器的特权密码,无法进入路由器的特权模式,普通用户模式下无权reload路由器,需要关闭路由器的电源,在路由器重启的60秒内,按住计算机的ctrl+c或ctrl+pause键,进入monitor模式。【cisco packet tracer按ctrl+c进入monitor模式】
monitor: command "boot" aborted due to user interrupt rommon 1 > confreg 0x2142 //修改配置寄存器值为 0x2142 使路由器不载入starting-config,进入默认配置
rommon 2 > reset //重启路由器
System Bootstrap, Version 12.1(3r)T2, RELEASE SOFTWARE (fc1)
Copyright (c) 2000 by cisco Systems, Inc.
cisco 2621 (MPC860) processor (revision 0x200) with 60416K/5120K bytes of memor
重启路由器后:
Router>en Router#conf t Enter configuration commands, one per line. End with CNTL/Z. Router(config)#enable password wusoft //重新设置特权密码 Router(config)#config-register 0x2102 //修改寄存值为 0x2102 恢复路由器默认状态。 Router(config)#exit Router# %SYS-5-CONFIG_I: Configured from console by console Router#wr Building configuration... [OK] Router#
重置路由器ENABLE特权密码过程结束,实验过程中只是修改了特权密码,对路由器其他配置没有影响
转载于:https://blog.51cto/adorablejacky/1261871
版权声明:本文标题:cisco packet tracer实验案例-重置路由器ENABLE特权密码 内容由热心网友自发贡献,该文观点仅代表作者本人, 转载请联系作者并注明出处:https://m.elefans.com/xitong/1727804554a1130903.html, 本站仅提供信息存储空间服务,不拥有所有权,不承担相关法律责任。如发现本站有涉嫌抄袭侵权/违法违规的内容,一经查实,本站将立刻删除。
发表评论